F3300H Exquisite Heat Accumulator

Product Series

The delicate heat (cold) accumulator is an instrument based on ARM microprocessor, which is used in conjunction with various flow transmitters and sensors to measure flow, and is used in conjunction with two platinum thermistors (or temperature transmitters) to measure liquid heat carrier heat or cold medium cold. It collects, displays, controls, transmits, communicates, prints and processes various signals such as temperature and flow rate on site, forming a digital acquisition system and control system, especially suitable for trade settlement and measurement management. It can be widely used in heating systems such as thermal oil boilers and water heating, as well as building air conditioning heat exchange systems, to achieve online measurement of heat and mass transfer, thereby providing a basis for enterprise energy management, energy consumption measurement, and technical economy.

Product Features:

·Storage function:

Equipped with USB function, supports exporting annual, monthly, and daily traffic reports

Can record the number of power outages, total power outage time, and last power outage time

·Prepaid management:

Can automatically close the valve and stop the service when the balance is zero

Support remote recharge or contactless IC card recharge

Two level passwords for supply and demand, different permissions to solve supply and demand management problems

·Computational function

Calculate the density, enthalpy, etc. of superheated steam and saturated steam according to the IF97 formula

Support temperature and pressure dual compensation, can automatically identify superheated steam and saturated steam

Ensure normal trade settlement under abnormal conditions of compensation end sensors

·Management function

Can enable protocol metering algorithms to measure high and low traffic

Capable of measuring peak, valley, and normal periods

Set daily and monthly quota quantities and allocate differences to achieve daily and monthly usage management

Non standard support:

·Support customized export report function

·Support customized settlement methods

·Support customization of heat calculation methods

Installation method:

·Step 1: Push the instrument into the installation hole from the front of the installation panel (please use a steel plate). The thickness of the installation panel is (1.5~6.5) mm.

·Step 2: Install the instrument panel using the mounting bracket as shown in the diagram above (one bracket is installed on each side of the instrument panel, and the screws used for the instrument panel mounting bracket are M4 standard screws).

·Step 3: After installing the instrument panel, you can connect the signal and power lines.

Send The Information To The Supplier